Sensor Installation

Heat Sensor Installation Procedures

1. Open the rear cover
2. Loosen the screws of the sensor on the connector
3. Remove the old sensor assuring not to move the outer protective tube
4. Place the new sensor
5. Fix the sensor to the connector
6. Pay attention not to allow any touch between two ends
7. Change the polarity (switch cable sides) when there is wrong temperature reading on the display. (Counting down when the heat goes up or other weird temperature readings)

New Sensor

1. Open the top cover
2. Remove the old sensor and connector
3. Open the back cover
4. Place the new sensor cable and shorten it if necessary
5. Drill two holes on the isolation box for the new connector as shown in the drawing
6. Insert the outer large tube in the upper hole leaving 3 mm outside the box.
7. Fix it to the box using a dental agent such as Wirovest or similar
8. Fix the sensor to the connector first
9. Then fix them together on the box and connect the cable
10. Change the polarity if necessary when a wrong temperature reading.(Counting down when the heat goes up or other weird temperature readings)

Leave a Reply